Viking · Denver
Dishwasher Repair
Fill, drain, spray and dry-cycle diagnostics on Viking integrated and panel-front dishwashers.
How it gets described on the phone
- Water still standing in the tub when the cycle ends
- Top rack comes out gritty while the bottom rack is clean
- Seeping at one corner of the door onto the floor
- Dishes come out soaking wet at the end of a cycle
Any of these is enough to work from. Model number and what changed just before it started are the two things that speed a visit up most.
What it usually is
Tested in this order
Fill, drain, spray and dry are four separate circuits. Which one is at fault is usually obvious from where the water is, or is not, at the end of a cycle.
-
The drain path, from air gap to disposer
Water standing in the tub is more often the path than the pump: a plugged air gap, a blocked disposer branch, or a corrugated hose that has sagged and holds a slug of water.
-
Fill side: inlet valve screen and latch switch
A cycle that runs with too little water leaves grit everywhere and full detergent cups. Either the inlet screen is choked or the door latch switch is telling the control the door is not shut.
-
Spray and dry: arms, feed tube, vent flap
Clean plates below and gritty ones above means the upper arm is not spinning or its feed tube is split. Everything soaking at the end usually means the vent flap has seized and the fan behind it has burnt out.
Worth knowing. Grit on the top rack is a spray problem, not a detergent problem. Changing brands will not fix it, and the test takes two minutes with the door open mid-cycle.
What it costs
What a dishwasher repair usually comes to
These are the ranges Viking work in Denver actually falls into — every kind of repair we carry out, so you can see where a dishwasher repair sits against the rest. Which end of a band your machine lands on depends on the part it needs and on how much cabinetry has to come out to reach it.
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
One figure for your own unit is agreed before anything is opened further or ordered, and the $89 service call is credited against it the moment you say go ahead. Nothing on this list is charged on top of a quote you have not seen.
Typical ranges · Viking · Denver
- Igniter or burner assembly
- $190–$420
- Oven thermostat or heating element
- $210–$480
- Refrigeration fan or defrost system
- $280–$690
- Dishwasher pump or control
- $200–$410
- Control board or touch panel
- $480–$620
- Compressor or sealed-system repair
- $1,370–$3,400
Worth the comparison. Going the other way — a comparable Viking replacement, before installation — runs $7,340–$16,940. Even the sealed-system band above is a fraction of that, which is why a machine like this is usually worth putting right rather than swapping out.
Reviews
Dishwasher Repair calls in Denver
Left after dishwasher repair visits across Denver.
4.9/ 51,300 reviews
Ours drains into the disposer and it kept backing up into the tub. The air gap under the sink was plugged solid. He cleared it, ran a full cycle, and taught me how to check it myself.
Ramona E.Platt Park
Detergent cup stayed full and nothing came out clean. The door latch switch was cutting the fill short. He replaced it and checked spray pressure afterwards. Fine now; a star off for a slipped appointment.
Fausto R.Platt Park
Water crept out at the left corner of the door and marked the floorboards. The seal had shrunk hard and one hinge spring was slack. He changed both. No damp since, in an old building that shows every drip.
Wilhelmina Q.Cheesman Park
Dishwasher Repair in Denver, booked in one call
Technicians out 8:00 am – 8:00 pm, seven days. The line is answered 24/7, and $89 covers the trip and the diagnosis.